Opbouw van de bierinstallatie

Which accessories do you need?   Foutenopsporing

Foutenopsporing This is a survey of the frequently asked questions. It contents an assortment of potential replies. Surely there are a lot of questions about troubles while operating with a tapping plant but this is only a list about the most occuring reasons. So the following answers are to understand as approaches only. Beer is not running Beer is foaming too much Beer has no foam or too little foam Beer looks muddy   Beer is not running Possible reason Approach Keg is empty Take a new keg Keg coupler is wrong Check whether you have the right one Keg coupler is jerry-built Check it Air bottle is empty Connect a new one Valves inside the coupler agglutinates Put them out and clean or renew them Low pressure of CO2 Enhance the pressure careful with small steps Carbonic acid escapes Check the lines about leaks (take a spray flask filled with 75 % water and 25 % detergent and spray it all over the bottle and line, in this way you find nearly all leaks) Beer line has snapped off Check all lines Beer line is frozen Switch off the cooler and check it Connecting of beer line and air line is wrong (mixed up) Check it Cleaning sponges remain in the line Flush them out with water Compensator tap is shut off Turn it on Gate valves are closed Turn them on   Beer is foaming too much Possible reason Approach Beer is too warm Check the temperature and regulate it Beer line is muddy Clean it Beer remains more than 5 days in the keg and contents too much CO2 It's better you take 2 small kegs than a big one otherwise you have to empty the big keg within 4 days Beer line has snapped off Check it Cooler is defect Check it by specialists or check the electric current There is a sag in the beer line Check it because all beer lines are to lay with gradient Correctly operation with the tap The tap always is to open completely Pressure is too high Reduce it (please note the previous pressure will stay for a little time) The intermediate regulator is adjusted in a wrong way, too much pressure Reduce it Cooling fails Check it, sometimes you have to fill in water and clean the device Isolation of beer line is insufficient Repair it with high efficiency Glasses has been washed with warm water Wash up with cold water Kegs have just arrived and had been shaking Transport them very careful   Beer has no foam or too little foam Possible reason Approach Beer is too cold Check the temperature and correct it Too low CO2-pressure Enhance the pressure very slowly and careful CO2 escapes Check the line about leaks (take a spray flask filled with 75 % water and 25 % detergent and spray it all over the bottle and line, in this way you find nearly all leaks) Glasses are dirty or cleaned with the wrong cleaner Please take only the right glass detergent and change the water a few times. Glasses are to clean first with warm water and after with cold water. Air bottle is empty Connect a new one The intermediate regulator is adjusted in a wrong way, too much pressure Reduce it   Beer is muddy Possible reason Approach Low temperature Check and correct it Beer keg has stored a very long time with the wrong temperatures Give the keg back to the brewery Cleaning of the tapping plant happened in a wrong way Clean it detailed again

Homepage   Contact

Products Catalog   Special offers of the month

About us   Brewery database Search